5 Easy Facts About Antminer t17 control board Described
5 Easy Facts About Antminer t17 control board Described
Blog Article
Software package Configuration: Routinely update your miner's firmware and maintain your mining computer software current. Proper configuration is key to exceptional efficiency.
Servicing staff are necessary to have a specific volume of electronic know-how, with at the very least one particular year of servicing experience and know-how in soldering technologies for example BGA, QFN, and LGA offers.
Notice: this information has Regular comparisons in between the T21 for the S21. They ended up launched at the same time, so it only makes sense.
This will likely advertise the chip pins and pads to re-operate, and afterwards the tin should be taken off to realize the impact of re-tinning. If the failure persists immediately after re-soldering, the chip ought to be replaced immediately.
7. Pull out the OTG cable or U disk, power about the control board once again, and after powering on, log in to the backstage to check whether it's the cardboard flashing version.
Following the file is ready, the complete miner should be installed for conventional ageing. This could make sure that the miner is performing accurately and can be employed efficiently.
If no problem is discovered by Visible inspection, the impedance of each and every voltage area can be tested to start with to detect no matter if You will find there's short circuit or an open circuit. If Sure, it have to be dealt with initial.
Program Servicing: Common cleaning and inspection can protect against numerous frequent troubles. This contains examining for firmware updates and making certain all factors batchminer are operating as envisioned.
Unexpectedly, the T21 bears the common Bitmain design with an extruded overall body and three hashboards within.
Put up-Improve Configuration: After the improve, reconfigure your miner configurations, such as the mining pool information. Perform a test operate to make sure the miner is operating the right way with the new firmware.
Re-electric power the hash board and Examine whether the Strengthen output is usual. The examination result's all around 18V, indicating that the Enhance module is changed productively.
Once the regime examination is OK, You need to use the ARC Tester to conduct chip detection, and ascertain the positioning according to the test fixture take a look at results.
Remember to Be aware which the firmware on the Miner model applicable to this control board differs, remember to spot an order in accordance with the accurate model
Examining the PIC soldering and programming is recommended. It’s well worth noting that it’s important to Check out the MOS from the corresponding group for a brief circuit.